Users Guide

Parameters
primary interface Enter the keyword primary to congure the primary interface then one of the
following interfaces and slot/port information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
•
For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
• For a port channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
secondary interface Enter the keyword secondary to congure the secondary interface then one of
the following interfaces and slot/port information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
•
For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
• For a port channel interface, enter the keywords port-channel then a
number.
control-vlan vlan-id Enter the keyword control-vlan then the VLAN ID. The range is from 1 to
4094.
Defaults none
Command Modes CONFIGURATION (conf-frrp)
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the C-Series.
7.4.1.0 Introduced.
Usage Information This command causes the Ring Manager to take ownership of the two ports after IFM validates the
conguration. Ownership is relinquished for a port only when the interface does not play a part in any control
VLAN, that is, the interface does not belong to any ring.
Related Commands show frrp — displays the Resilient Ring Protocol conguration information.
Force10 Resilient Ring Protocol (FRRP)
603