Users Guide

To disable debugging, use the no debug gvrp {config | events | pdu} command.
Parameters
cong Enter the keyword config to enable debugging on the GVRP conguration.
event Enter the keyword event to enable debugging on the JOIN/LEAVE events.
pdu Enter the keyword pdu then one of the following Interface keywords and slot/port
or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
•
For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
• For a port channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
Defaults Disabled.
Command Modes EXEC
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on C-Series, E-Series, and S-Series
disable
Globally disable GVRP.
S4820T
Syntax
disable
To re-enable GVRP, use the no disable command.
Defaults Enabled.
Command Modes CONFIGURATION-GVRP
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
GARP VLAN Registration (GVRP)
611