Users Guide
redundancy reset-counter
Reset failover counter and timestamp information displayed in the show redundancy command.
S4820T
Syntax
redundancy reset-counter
Default Not congured.
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the E-Series.
redundancy sfm standby
Place the SFM in an oine state.
S4820T
Syntax
redundancy sfm standby
To place the SFM in an online state, use the no redundancy sfm standby command.
Default The SFM is online by default.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
7.5.1.0 Introduced on the C-Series.
Usage Information When you insert or remove a secondary RPM with logical SFM, the system must add or remove the
backplane links to the switch fabric trunk. To avoid trac disruption, use this command when you insert the
626
High Availability (HA)