Users Guide

To delete a specic multicast router interface, use the no igmp snooping mrouter interface
interface command.
Parameters
interface interface Enter the following keywords and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
•
For a port channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
Defaults Not congured.
Command Modes INTERFACE VLAN — (conf-if-vl-n)
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-
Mux (PMUX) mode only.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command.
Usage Information Dell Networking OS provides the capability of statically conguring the interface to which a multicast router
is attached. To congure a static connection to the multicast router, enter the ip igmp snooping
mrouter interface command in the VLAN context. The interface to the router must be a part of the
VLAN where you are entering the command.
ip igmp snooping querier
Enable IGMP querier processing for the VLAN interface.
S4820T
Syntax
ip igmp snooping querier
654
Internet Group Management Protocol (IGMP)