Users Guide

To disable IGMP querier processing for the VLAN interface, use the no ip igmp snooping querier
command.
Defaults Not congured.
Command Modes INTERFACE VLAN — (conf-if-vl-n)
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-
Mux (PMUX) mode only.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage Information This command enables the IGMP switch to send General Queries periodically. This behavior is useful when
there is no multicast router present in the VLAN because the multicast trac is not routed. Assign an IP
address to the VLAN interface for the switch to act as a querier for this VLAN.
show ip igmp snooping groups
Display snooping related information for all the IGMP groups, interface or one group of one interface.
S4820T
Syntax
show ip igmp snooping groups [group-address [detail] | detail | interface
[group-address [detail]]]
Parameters
snooping Enter the keyword snooping to display snooping related information.
group-address (OPTIONAL) Enter the group address in dotted decimal format to view information
on that group only.
interface (OPTIONAL) Enter the interface type and slot/port information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
•
For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
Internet Group Management Protocol (IGMP)
655