Users Guide

interface loopback
Congure a Loopback interface.
S4820T
Syntax
interface loopback number
To remove a loopback interface, use the no interface loopback number command.
Parameters
number Enter a number as the interface number. The range is from 0 to 16383.
Defaults Not congured.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.4.1.0 Introduced
Example
Dell(conf)#interface loopback 1655
Dell(conf-if-lo-1655)#
Related Commands
interface — congures a physical interface.
interface null — congures a Null interface.
interface port-channel — congures a port channel.
interface vlan — congures a VLAN.
interface ManagementEthernet
Congure the Management port on the system (either the Primary or Standby RPM).
S4820T
Syntax
interface ManagementEthernet slot/port
Interfaces
669