Users Guide

• If overlapping port ranges are specied, the port range is extended to the smallest start port and the
biggest end port.
Example (Bulk)
Dell(conf)#interface range tengigbitethernet 2/1 - 11, fortyGigbE 3/3,
tengigbitethernet 3/10
% Warning: Non-existing ports (not configured) are ignored by
interface-range
Example (Multiple
Ports)
Dell(conf)#interface range tengigabitethernet 2/10 - 23,
tengigabitethernet 2/12 - 17
Dell(conf-if-range-te-2/10-23)#
Example
(Overlapping Ports)
Dell(conf)#interface range tengigabitethernet 2/3 - 11, tengigabitethernet
2/3 - 23
Dell(conf-if-range-te-2/3-23)#
Usage Information
Only VLAN and port-channel interfaces created using the interface vlan and interface port-
channel commands can be used in the interface range command.
Use the show running-config command to display the VLAN and port-channel interfaces. VLAN or
port-channel interfaces that are not displayed in the show running-config command cannot be used
with the bulk conguration feature of the
interface range command. You cannot create virtual
interfaces (VLAN, Port-channel) using the interface range command.
NOTE: If a range has VLAN, physical and port-channel interfaces, only commands related to
physical interfaces can be bulk congured. To congure commands specic to VLAN and port-
channel only those respective interfaces should be congured in a particular range.
Example (Single
Range)
This example shows a single range bulk conguration.
Dell(config)# interface range tengigabitethernet 5/3 - 23
Dell(config-if-range-te-5/3-23)# no shutdown
Dell(config-if-range-te-5/3-23#
Example (Multiple
Range)
This example shows how to use commas to add dierent interface types to the range enabling all Tengigabit
Ethernet interfaces in the range 5/1 to 5/23 and both Tengigabit Ethernet interfaces 1/1 and 1/2.
Dell(config-if)# interface range tengigabitethernet 5/1 - 5/23,
tengigabitethernet 1/1 - 1/2
Dell(config-if-range-te-1/1-2,te-5/1-23)# no shutdown
Dell(config-if-range-te-1/1-2,te-5/1-23)#
Example (Multiple
Range)
This example shows how to use commas to add VLAN and port-channel interfaces to the range.
Dell(config-if)# interface range tengigabitethernet 5/1 - 23,
tengigabitethernet 1/1 – 2,
Vlan 2–100, Port 1–25
Dell(config-if-range-te-1/1-2,te-5/1-23,vl-2-100,po-1-25)# no shutdown
Dell(config-if-range-te-5/1-24,te-1/1-2,vl-2-100,po-1-25)#
Related Commands
interface port-channel — congures a port channel group.
interface vlan — congures a VLAN interface.
show cong (from INTERFACE RANGE mode) — shows the bulk conguration interfaces.
show range — shows the bulk conguration ranges.
Interfaces
673