Users Guide

Example (Single
Range)
This example shows the macro named test that was dened earlier.
Dell(config)#interface range macro test
Dell(config-if-range-te-1/1-3,te-5/1-47,te-13/1-89)#
Dell
Related Commands
interface range — congures a range of command (bulk conguration).
interface range macro (dene) — denes a macro for an interface range (bulk conguration).
interface vlan
Congure a VLAN. You can congure up to 4094 VLANs.
S4820T
Syntax
interface vlan vlan-id [of-instance{of-id}]
Parameters
of-instance{of-id} Enter the keyword of-instance then the OpenFlow instance ID to add the VLAN to
the specied OpenFlow instance. The range is from 1 to 8.
NOTE: Associate the OpenFlow instance with the VLAN when the VLAN is
created. An existing VLAN cannot be associated with an OpenFlow
instance.
Defaults Not congured, except for the Default VLAN, which is congured as VLAN 1.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.0.2.0 Introduced on the S6000.
9.1.(0.0) Introduced on the S4810; added support for OpenFlow.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
Usage Information
For more information about VLANs and the commands to congure them, refer to the Virtual LAN (VLAN)
Commands section of the Layer 2 chapter.
FTP, TFTP, and SNMP operations are not supported on a VLAN. MAC ACLs are not supported in VLANs. IP
ACLs are supported. For more information, refer to the Access Control Lists (ACL) chapter.
The following features are not supported on VLANs associated with an OpenFlow instance:
• IPv4
• IPv6
• MTU
676
Interfaces