Users Guide

NOTE: The Dell Networking OS implementation of LAG or Port Channel requires that you congure a LAG on both
switches manually. For information about Dell Networking OS link aggregation control protocol (LACP) for dynamic
LAGs, refer to the Link Aggregation Control Protocol (LACP) chapter. For more information about conguring and using
Port Channels, refer to the Dell Networking OS Conguration Guide .
channel-member
Add an interface to the Port Channel, while in INTERFACE PORTCHANNEL mode.
S4820T
Syntax
channel-member interface
To delete an interface from a Port Channel, use the no channel-member interface command.
Parameters
interface (OPTIONAL) Enter any of the following keywords and slot/port or number
information:
• For a 100/1000 Ethernet interface, enter the keyword GigabitEthernet
then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
Defaults Not congured.
Command Modes INTERFACE PORTCHANNEL
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-Version 6.2.1.0 Introduced on the E-Series.
Usage Information
Use the interface port-channel command to access this command.
Interfaces
719