Users Guide

Parameters
channel-number For a Port Channel interface, enter the keyword port-channel then a number.
For the C-Series and S-Series, the range is from 1 to 128.
brief (OPTIONAL) Enter the keyword brief to display only the port channel number,
the state of the port channel, and the number of interfaces in the port channel.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series. Modied to display the LAG failover group status.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage Information The following describes the show interfaces port-channel command shown in the following
example.
Field Description
Port-Channel 1... Displays the LAG’s status. In the Example, the status of the LAG’s LAG fate-
sharing group (“Failover-group”) is listed.
Hardware is... Displays the interface’s hardware information and its assigned MAC address.
Port-channel is
part...
Indicates whether the LAG is part of a LAG fate-sharing group (“Failover-group”).
Internet address... States whether an IP address is assigned to the interface. If an IP address is
assigned, that address is displayed.
MTU 1554... Displays link and IP MTU.
LineSpeed Displays the interface’s line speed. For a port channel interface, it is the line speed
of the interfaces in the port channel.
Members in this... Displays the interfaces belonging to this port channel.
ARP type:... Displays the ARP type and the ARP timeout value for the interface.
Last clearing... Displays the time when the show interfaces counters were cleared.
Interfaces
725