Users Guide

show ip udp-helper
Display the congured UDP helpers on all interfaces.
S4820T
Syntax
show ip udp-helper
Defaults none
Command Modes EXEC
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Pre-version 8.3.7.0 Introduced on the E-Series ExaScale.
Example
Dell#show ip udp-helper
--------------------------------------------------
Port UDP port list
--------------------------------------------------
Te 10/2 656, 658
Te 10/3 All
Related Commands
debug ip udp-helper — enables debug and displays the debug information on a console.
ip udp-broadcast-address — congures a UDP IP address for broadcast.
ip udp-helper udp-port — enables the UDP broadcast feature on an interface either for all UDP ports or a
specied list of UDP ports.
Enhanced Validation of Interface Ranges
This functionality is supported on the S4820T platform.
You can avoid specifying spaces between the range of interfaces, separated by commas, that you congure by using the
interface range command. For example, if you enter a list of interface ranges, such as interface range fo 2/0-1,te
10/0,gi 3/0,fa 0/0
, this conguration is considered valid. The comma-separated list is not required to be separated by spaces
in between the ranges. You can associate multicast MAC or hardware addresses to an interface range and VLANs by using the mac-
address-table static
multicast-mac-address vlan vlan-id output-range interface command.
734
Interfaces