Users Guide
To disable proxy ARP, use the no ip proxy-arp command.
Defaults Enabled.
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Related Commands show ip interface — displays the interface routing status and conguration.
ip route
Assign a static route to the switch.
S4820T
Syntax
ip route [vrf vrf-name] ip-address mask {ip-address | interface [ip-
address]} [distance] [permanent] [tag tag-value] [vrf vrf-name] [weight
weight-value]
To delete a specic static route, use the no ip route destination mask command.
To delete all routes matching a certain route, use the no ip route destination mask command.
Parameters
vrf vrf-name (Optoinal) Enter the keyword vrf and then the name of the VRF to congure a
static route corresponding to that VRF. Use this VRF option after the ip route
keyword to congure a static route on that particular VRF.
destination Enter the IP address in dotted decimal format of the destination device.
mask Enter the mask in the slash prex format (/x) of the destination IP address.
ip-address Enter the IP address of the forwarding router in dotted decimal format.
interface Enter one of the following keyword followed by the slot/port number:
772
IPv4 Routing