Users Guide

• source-mac — Uses the source MAC address, VLAN, Ethertype, source

module ID and source port ID elds to hash. The hashing mechanism returns a

3-bit index indicating which port the packet should be forwarded.

tcp-udp enable Enter the keywords to distribute trac based on the following:

• enable — Takes the TCP/UDP source and destination ports into

consideration when doing hash computations. This option is enabled by default.

ingress-port enable Enter the keywords to distribute trac based on the following:

• enable — Takes the source port into consideration when doing hash

computations. This option is disabled by default.

Defaults IP 4-tuple (IP SA, IP DA, Source Port, Destination Port)

Command Modes CONFIGURATION

Command History

This guide is platform-specic. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.10.0 Added the ingress-port parameter for the S4810.

8.3.7.0 Introduced on the S4810.

7.6.1.0 Introduced on the S-Series.

7.5.1.0 Introduced on the C-Series.

Usage Information By default, Dell Networking OS distributes incoming trac based on a hash algorithm using the following

criteria:

• IP source address

• IP destination address

• TCP/UDP source port

• TCP/UDP destination port

load-balance hg

Choose the trac ow parameters the hash calculation uses while distributing the trac across internal higig links.

Syntax

[no] load-balance hg {ip-selection | ipv6-selection [source-ip | source-

778

IPv4 Routing