Users Guide

show ip cam stack-unit
Display CAM entries for a port-pipe of a stack-unit on a S-Series or Z-Series switch.
Syntax
show ip cam stack-unit {stack-unit-number} [port-set {pipe-number} | vrf vrf-name {ip-
address mask [longer-prefixes [ecmp-group detail]]}| ecmp-group {detail | member-info
[detail [group-index index-number]]}| summary]
Parameters
stack-unit-number Enter the stack-unit ID.
port-set pipe-
number
Enter the keyword port-set then the number of the stack unit’s port-pipe. The unit ID range is from 0
to 0.
network mask
[longer-prexes
[ecmp-group
detail]]
(OPTIONAL) Enter the IP address and mask of a route to CAM entries for that route only. You can enter
one of the following keywords to lter results.
• Enter the keyword longer-prefixes to view routes with a common prex.
• Enter the keyword ecmp-group detail to view the ECMP group index.
ecmp-group {detail
| member-info
[detail [group-index
index-number]]}
(OPTIONAL) Enter the keyword ecmp-group then one of the following keywords to lter results.
• Enter the keyword detail to view the ECMP group index.
• Enter the keyword member-info to view the member information for the ECMP group.
• Enter the keyword member-info detail to view detailed ECMP membership and n-hop
information.
• Enter the keyword group-index then the index number to show ECMP membership per group.
The range is from 0 to 1022.
summary (OPTIONAL) Enter the keyword summary to view a table listing route prexes and the total number
routes which can be entered in to CAM.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell Networking OS
Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Added support for VRF.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Added support for up to seven stack members.
7.6.1.0 Introduced on the S-Series.
Usage Information The following describes the show ip cam command shown in the following example.
IPv4 Routing
789