Users Guide

show ip b linecard
View all forwarding information base (FIB) entries.
S4820T
Syntax
show ip fib linecard slot-number [vrf vrf instance | ip-address/prefix-list |
summary]
Parameters
vrf instance (OPTIONAL) E-Series Only: Enter the keyword vrf then the VRF instance name to show
the FIB cache entries tied to that VRF instance.
slot-number Enter the number of the line card slot.
ip-address mask (OPTIONAL) Enter the IP address of the network destination to view only information on
that destination. Enter the IP address is dotted decimal format (A.B.C.D). Enter the mask
in slash prex format (/X).
longer-prexes (OPTIONAL) Enter the keywords longer-prefixes to view all routes with a common
prex.
summary (OPTIONAL) Enter the keyword summary to view the total number of prexes in the FIB.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.9.1.0 Introduced VRF on the E-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version 6.1.1.0 Introduced on the E-Series.
Usage Information The following describes the show ip fib command shown in the following example.
Field Description
Destination Lists the destination IP address.
Gateway Displays either the word “direct” and an interface for a directly connected route or the
remote IP address used to forward the trac.
First-Hop Displays the rst hop IP address.
Mac-Addr Displays the MAC address.
Port Displays the egress-port information.
VId Displays the VLAN ID. If no VLAN is assigned, zero (0) is listed.
Index Displays the internal interface number.
IPv4 Routing
791