Users Guide

brief (OPTIONAL) Enter the keyword brief to view a brief summary of the interfaces
and whether an IP address is assigned.
congured (OPTIONAL) Enter the keyword configured to display the physical interfaces
with non-default congurations only.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
8.1.1.2 Supported on the E-Series ExaScale E600i.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage Information The following describes the show ip interface command shown in the following example.
Lines Description
TenGigabitEthernet
1/1...
Displays the interface’s type, slot/port, and physical and line protocol status.
Internet address... States whether an IP address is assigned to the interface. If an IP address is
assigned, that address is displayed.
IP MTU is... Displays IP MTU value.
Inbound access... Displays the name of the congured incoming access list. If none is congured, the
phrase “not set” is displayed.
Proxy ARP... States whether proxy ARP is enabled on the interface.
Split horizon... States whether split horizon for RIP is enabled on the interface.
Poison Reverse... States whether poison for RIP is enabled on the interface.
ICMP redirects... States if ICMP redirects are sent.
ICMP
unreachables...
States if ICMP unreachable messages are sent.
796
IPv4 Routing