Users Guide

ipv6 address eui64
Congure IPv6 EUI64 address conguration on the interface.
S4820T
Syntax
ipv6 address {ipv6-address prefix-length} eui64
To disable IPv6 EUI64 address autoconguration, use the no ipv6 address {ipv6-address
prefix-length} eui64 command.
Parameters
ipv6-address prex-
length
Enter the IPv6 prex in the x:x:x:x::x format then the prex length in the /x format.
The range is from /0 to /128.
NOTE: The :: notation species successive hexadecimal elds of zeros.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.2(0.2) Introduced.
Usage Information This command allows you to create an EUI64 address based on the specied prex and MAC address only.
Prexes may be congured on the interface using the ipv6 nd prefix command without creating an
EUI64 address.
Example
Dell(conf)#int ten 1/4
Dell(conf-if-te-1/4)#ipv6 address 200:1::/64 eui64
Dell(conf)#int ten 1/6
Dell(conf-if-te-1/6)#ipv6 address 801:10::/64 eui64
ipv6 control-plane icmp error-rate-limit
Congure the maximum number of ICMP error packets per second that can be sent per second.
S4820T
Syntax
ipv6 control-plane icmp error-rate-limit {1-200}
To restore the default value, use the no ipv6 control-plane icmp error-rate-limit
command.
826
IPv6 Basics