Users Guide
Parameters
pps Enter the maximum number of error packets generated per second. The range is
from 1 to 200, where 0 disables the rate-limiting.
Default 100 pps
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
ipv6 owlabel-zero
Congure system to set the ow label eld in the packets to zero.
S4820T
Syntax
ipv6 flowlabel-zero
To disable the 0 from being set in the eld and allow the protocol operations to ll the eld, use the no
ipv6 flowlabel-zero command.
Default Disabled
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Usage Information If the owlabel value is already set for BGP or SSH, the system defaults to the already congured value. All
packets on the same connection are considered part of the same ow by the system. For new connections,
set the new owlabel to zero.
IPv6 Basics
827