Users Guide

show ipv6 cam stack-unit
Displays the IPv6 CAM entries for the specied stack-unit.
S4820T
Syntax
show ipv6 cam [vrf vrf-name] stack-unit unit-number port-set {0-1} [summary
| index | ipv6 address]
Parameters
vrf vrf-name (Optional) Enter the keyword vrf followed by the name of the VRF to display IPv6
CAM entries corresponding to that VRF.
NOTE: If you do not specify this option, IPv6 CAM entries corresponding to
the default VRF are displayed.
unit-number Enter the stack unit’s ID number.
port-set Enter the keyword Port Set.
summary (OPTIONAL) Enter the keyword summary to display a table listing network
prexes and the total number prexes which can be entered into the IPv6 CAM.
index (OPTIONAL) Enter the index in the IPv6 CAM.
ipv6-address Enter the IPv6 address in the x:x:x:x::x/n format to display networks that have
more specic prexes. The range is from /0 to /128.
NOTE: The :: notation species successive hexadecimal elds of zeros.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Added support for VRF.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.7.1 Introduced on the S4810.
8.4.2.1 Introduced on the S-Series.
Usage Information
First-Hop information is not shown for installed routes in the IPv6 content addressable memory (CAM).
However, the same is shown in the forwarding information base (FIB).
IPv6 Basics
835