Users Guide

iscsi target port
Congure the iSCSI target ports and optionally, the IP addresses on which iSCSI communication is monitored.
S4820T
Syntax
iscsi target port [tcp-port-2...tcp-port-16]ip-address [ip-address]
To remove the congured iSCSI target ports or IP addresses, use the no iscsi target port
command.
Parameters
tcp-
port-2...tcpport- 16
Enter the tcp-port number of the iSCSI target ports. The tcp-port-n is the TCP
port number or a list of TCP port numbers on which the iSCSI target listens to
requests. Separate port numbers with a comma. The default is 860, 3260.
ip-address
(Optional)
Enter the ip-address that the iSCSI monitors. The ip-address species the IP
address of the iSCSI target.
Defaults 860, 3260
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on MXL 10/40GbE Switch IO Module.
Usage Information
You can congure up to 16 target TCP ports on the switch in one command or multiple commands.
When you use the no iscsi target port command and the TCP port you wish to delete is one bound
to a specic IP address, the IP address value must be included in the command.
show iscsi
Display the currently congured iSCSI settings.
Syntax
show iscsi
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
850
iSCSI Optimization