Users Guide

Usage Information You can assign a name to a routing process so a prex list IS applied to only the routes derived from the
specied routing process.
Related Commands
• distribute-list in — lters the networks received in updates.
• redistribute — redistributes routes from one routing domain to another routing domain.
distribute-list redistributed-override
Suppress apping of routes when the same route is redistributed into IS-IS from multiple routers in the network.
Syntax
distribute-list redistributed-override in
To return to the default, use the no distribute-list redistributed-override in command.
Defaults none
Command Modes
• ROUTER ISIS (for IPv4)
• CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6)
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
7.8.1.0 Added IPv6 ISIS support.
6.3.1.0 Introduced.
Usage Information When you execute this command, IS-IS does not download the route to the routing table if the same route
was redistributed into IS-IS routing protocol on the same router.
domain-password
Set the authentication password for a routing domain.
Syntax
domain-password [hmac-md5 | encryption-type] password
To disable the password, use the no domain-password command.
Parameters
hmac-md5 (OPTIONAL) Enter the keywords hmac-md5 to encrypt the password using MD5.
868
Intermediate System to Intermediate System (IS-IS)