Users Guide
4
Control and Monitoring
This chapter contains the commands to congure and monitor the system, including Telnet, le transfer protocol (FTP), and trivial
le transfer protocol (TFTP).
NOTE: This command replaces the enable optic-info-update interval command to update information on
temperature and power monitoring in the simple network management protocol (SNMP) management information base
(MIB).
asf-mode
Enable alternate store and forward (ASF) mode and forward packets as soon as a threshold is reached.
Syntax
asf-mode stack-unit {unit-id | all} queue size
To return to standard Store and Forward mode, use the no asf-mode stack unit command.
Parameters
unit-id Enter the stack member unit identier of the stack member to reset. The S4820T
range is from 0 to 11.
NOTE: The S4820T commands accept Unit ID numbers from 0 to 11,
though S4820T supports stacking of up to six units.
queue size Enter the queue size of the stack member. The range is from 0 to 15.
Defaults Not congured
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
8.3.19.0 Introduced on the S4820T.
8.3.11.0 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Usage Information You must save the conguration and reload the system to implement ASF. When you enter the command,
the system sends a message stating that the new mode is enabled when the system reloads.
Control and Monitoring
87