Users Guide

If metric value is congured to more than 63, system throughs the following
warning:Warning: for metrics greater than 63, 'metric-style
wide' should be configured on level-1-2, or it will be
capped at 63.
If the metric style is WIDE, the metric values that are greater than 63 are only
eective.
level-1 (OPTIONAL) Enter the keywords level-1 to congure the shortest path rst
(SPF) calculation for Level 1 (intra-area) routing. This setting is the default.
level-2 (OPTIONAL) Enter the keywords level-2 to congure the SPF calculation for
Level 2 (inter-area) routing.
Defaults default-metric = 10; level-1 (if not otherwise specied)
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
Usage Information
Dell Networking recommends conguring metrics on all interfaces. Without conguring this command, the
IS-IS metrics are similar to hop-count metrics.
isis network point-to-point
Enable the software to treat a broadcast interface as a point-to-point interface.
Syntax
isis network point-to-point
To disable the feature, use the no isis network point-to-point command.
Defaults Not enabled.
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Intermediate System to Intermediate System (IS-IS)
883