Users Guide

Enter 4 or 8 for the number of OpenFlow FP blocks.

• 4: Creates 242 entries for use by the OpenFlow controller (256 total entries

minus the 14 entries reserved for internal functionality)

• 8: Creates 498 entries for use by the OpenFlow controller (512 total entries

minus the 14 entries reserved for internal functionality)

Using the fcoe parameter, enter the number of FP groups to be allocated for

FCoE transit. Enter 1 – 6; maximum six groups. Each group has 128 entries,

creating a total of 768 possible entries for FCoE FP groups. The value given must

be an even number.

Command Modes CONFIGURATION

Command History

This guide is platform-specic. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0 Introduced on the S6000.

9.2(0.2) Added support for the fcoe parameter on the S4810 and S4820T.

9.1.(0.0) Added support for OpenFlow on the Z9000.

8.3.19.0 Introduced on the S4820T.

8.3.12.0 Added the keywords fcoeacl and iscsioptacl on the S4810.

8.3.11.1 Introduced on the Z9000.

8.3.1.0 Added the keywords ecfmacl, vman-qos, and vman-dual-qos.

8.2.1.0 Introduced on the S-Series.

7.8.1.0 Introduced on the C-Series.

Usage Information

For the new settings to take eect, save the new CAM settings to the startup-cong (write-mem or

copy run start) then reload the system.

The total amount of space allowed is 16 FP Blocks. System ow requires three blocks and these blocks

cannot be reallocated. The ipv4acl prole range is from 1 to 4.

When conguring space for IPv6 ACLs, the total number of Blocks must equal 13.

Ranges for the CAM proles are from 1 to 10, except for the ipv6acl prole which is from 0 to 10. The

ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10).

If you enabled BMP, to perform a reload on the chassis to upgrade any conguration changes that have

changed the NVRAM content, use the reload conditional nvram-cfg-change command.

Control and Monitoring