Users Guide
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.1(0.0) Added support for output range parameter for S4810 and Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.2.1.1 Introduced on the E-Series.
Example (Unicast)
mac-address-table static 00:01:00:00:00:01 {output Te 1/2 vlan 2}
Example (Multicast)
mac-address-table static 01:00:5E:01:00:01 {multicast vlan 2 output—range
Te 1/2,Te 1/3}
Related Commands show mac-address-table — displays the MAC address table.
mac-address-table station-move threshold
Change the frequency with which the MAC address station-move trap is sent after a MAC address changes in a VLAN. A trap is
sent if a station move is detected above a threshold number of times in a given interval.
S4820T
Syntax
[no] mac-address-table station-move threshold number interval count
Parameters
threshold number Enter the keyword threshold then the number of times MAC addresses in
VLANs can change before an SNMP trap is sent. The range is from 1 to 10.
interval seconds Enter the keyword interval then the number of seconds. The range is from 5 to
60.
Defaults Not congured.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
8.3.19.0 Introduced on the S4820T.
924
Layer 2