Deployment Guide

28 Dell EMC Networking OS10 Enterprise Edition Switch Configuration Guide for VxRail 4.5
S5148F-Leaf1A
S5148F-Leaf1B
switchport trunk allowed vlan 1612-
1615
spanning-tree port type edge
flowcontrol receive on
flowcontrol transmit off
no shutdown
interface ethernet1/1/18
description Node2_Port1
switchport mode trunk
switchport access vlan 1611
switchport trunk allowed vlan 1612-
1615
spanning-tree port type edge
flowcontrol receive on
flowcontrol transmit off
no shutdown
interface ethernet1/1/19
description Node3_Port1
switchport mode trunk
switchport access vlan 1611
switchport trunk allowed vlan 1612-
1615
spanning-tree port type edge
flowcontrol receive on
flowcontrol transmit off
no shutdown
interface ethernet1/1/20
description Node4_Port1
switchport mode trunk
switchport access vlan 1611
switchport trunk allowed vlan 1612-
1615
spanning-tree port type edge
flowcontrol receive on
flowcontrol transmit off
no shutdown
switchport trunk allowed vlan 1612-
1615
spanning-tree port type edge
flowcontrol receive on
flowcontrol transmit off
no shutdown
interface ethernet1/1/18
description Node2_Port2
switchport mode trunk
switchport access vlan 1611
switchport trunk allowed vlan 1612-
1615
spanning-tree port type edge
flowcontrol receive on
flowcontrol transmit off
no shutdown
interface ethernet1/1/19
description Node3_Port2
switchport mode trunk
switchport access vlan 1611
switchport trunk allowed vlan 1612-
1615
spanning-tree port type edge
flowcontrol receive on
flowcontrol transmit off
no shutdown
interface ethernet1/1/20
description Node4_Port2
switchport mode trunk
switchport access vlan 1611
switchport trunk allowed vlan 1612-
1615
spanning-tree port type edge
flowcontrol receive on
flowcontrol transmit off
no shutdown
7.2.4 Configure the switch interconnect
Create a port channel to use between the two leaf switches, 127 in this example. Use the switchport
mode trunk command to enable the port channel to carry traffic for multiple VLANs, and allow all VLANs on
the port channel.
Use 100GbE interfaces for the port channel, 1/1/53 and 1/1/54 in this example. Add each interface to the port
channel as LACP active members with the channel-group 127 mode active command.
When the configuration is complete, exit configuration mode and save the configuration with the end and
write memory commands.