Deployment Guide

7 Dell EMC Networking OS10 Enterprise Edition Switch Configuration Guide for VxRail 4.5
2 Hardware overview
This section briefly describes the hardware used to validate this deployment. Appendix A and Appendix B
contain a complete listing of hardware and software validated for this guide.
2.1 Dell EMC PowerSwitch S5148F-ON
The S5148F-ON is a 1-RU, multilayer switch with 48x25GbE, and 6x100GbE or 72x25GbE ports. This guide
uses two S5148F-ONs as leaf switches.
Dell EMC PowerSwitch S5148F-ON
2.2 Dell EMC PowerSwitch S3048-ON
The S3048-ON is a 1-RU switch with 48x1GbE BASE-T ports and 4x10GbE SFP+ ports. This guide uses one
S3048-ON switch for out-of-band (OOB) management traffic.
Dell EMC PowerSwitch S3048-ON
2.3 Dell EMC VxRail 14G nodes
Current Dell EMC VxRail P, V, S, and E Series nodes are built on 14
th
generation (14G) PowerEdge servers.
P, V, and S Series nodes use a 2-RU form factor, as shown in Figure 4.
Dell EMC VxRail 2-RU node (P, V, and S Series)
Dell EMC VxRail E Series nodes use a 1-Rack Unit (RU) form factor, as shown in Figure 5.
Dell EMC VxRail E Series node