Users Guide

Default Not congured
Command Mode MONITOR-SESSION
Usage Information The no version of this command resets the value to the default.
Example
OS10(conf-mon-local-10)# destination interface port-channel 10
Supported Releases 10.2.0E or later
monitor session
Creates a session for monitoring trac with port monitoring.
Syntax
monitor session session-id type local ]
Parameters
• session-id — Enter a monitor session ID (1 to 18).
• local — (Optional) Enter a local monitoring session.
Default local
Command Mode CONFIGURATION
Usage Information The no version of this command removes the monitor session.
Example
OS10(config)# monitor session 1
OS10(conf-mon-local-1)#
Supported Releases 10.2.0E or later
show monitor session
Displays information about a monitoring session.
Syntax
show monitor session {session-id | all}
Parameters
• session-id — Enter the session ID number (1 to 18).
• all — View all monitoring sessions.
Default All
Command Mode EXEC
Usage Information In the State eld, true indicates that the port is enabled. In the Reason eld, Is UP indicates that hardware
resources are allocated .
Example
OS10# show monitor session all
S.Id Source Destination Dir SrcIP DstIP DSCP TTL State Reason
----------------------------------------------------------------------
1 ethernet1/1/6 port-channel10 rx N/A N/A N/A N/A true Is UP
Supported Releases 10.2.0E or later
Layer 2 185