Users Guide

• dscp value — (Optional) Deny a packet based on the DSCP values, from 0 to 63.
• fragment — (Optional) Use ACLs to control packet fragments.
• host ipv6–address — (Optional) Enter the IPv6 address to use a host address only.
Default Not congured
Command Mode IPV6-ACL
Usage Information The no version of this command removes the lter.
Example
OS10(config)# ipv6 access-list ipv6test
OS10(conf-ipv6-acl)# deny ipv6 any any capture session 1
Supported Releases 10.2.0E or later
deny tcp
Congures a lter that drops transmission control protocol (TCP) packets meeting the lter criteria.
Syntax
deny tcp [A.B.C.D | A.B.C.D/x | any | host ip-address [operator]] [[A.B.C.D |
A.B.C.D/x | any | host ip-address [operator]] [ack | fin | psh | rst | syn |
urg] [capture | dscp value | fragment]
Parameters
• A.B.C.D — Enter the IP address in A.B.C.D format.
• A.B.C.D/x — Enter the number of bits to match in A.B.C.D/x format.
• any — (Optional) Enter to subject all routes to the lter:
• capture — (Optional) Capture packets the lter processes.
• dscp value — (Optional) Deny a packet based on the DSCP values, from 0 to 63.
• fragment — (Optional) Use ACLs to control packet fragments.
• ack — (Optional) Set the bit as acknowledgement.
• fin — (Optional) Set the bit as nish—no more data from sender.
• psh — (Optional) Set the bit as push.
• rst — (Optional) Set the bit as reset.
• syn — (Optional) Set the bit as synchronize.
• urg — (Optional) Set the bit set as urgent.
• operator — (Optional) Enter a logical operator to match the packets on the specied port number. The
following options are available:
• eq — Equal to
• gt — Greater than
• lt — Lesser than
• neq — Not equal to
• range — Range of ports, including the specied port numbers.
• host ip-address — (Optional) Enter the keyword and the IP address to use a host address only.
Default
Not congured
Command Mode IPV4-ACL
Usage Information The no version of this command removes the lter.
Access Control Lists 385