Users Guide
policy-map
Enters QoS POLICY-MAP mode and creates or modies a QoS policy-map.
Syntax
policy-map policy-map-name [type {qos | queuing | control-plane | application}]
Parameters
• policy-map-name — Enter a class name for the policy-map (up to 32 characters).
• type — Enter the policy-map type.
• qos — Create a qos policy-map type.
• queuing — Create a queueing policy-map type.
• control-plane — Create a control-plane policy-map type.
• application — Create an application policy-map type.
Defaults qos = class-map type and match-any = class-map lter
Command Mode CONFIGURATION
Usage Information The no version of this command deletes a policy-map.
Example
OS10(config)# policy-map p1
Example (Queuing)
OS10(config)# policy-map type queuing p1
Supported Releases 10.2.0E or later
priority
Sets the scheduler as a strict-priority.
Syntax
priority
Parameters None
Default WDRR — when priority is mentioned, it moves to SP with default level 1
Command Mode POLICY-MAP-CLASS-MAP
Usage Information If you use this command, bandwidth is not allowed. Only the egress QoS policy type supports this command.
Example
OS10(conf-pmap-que)# priority
Supported Releases 10.2.0E or later
qos-group dot1p
Congures a dot1p trust map to the trac class.
Syntax
qos-group tc-list [dot1p values]
Parameters
• qos-group tc-list — Enter the trac single value class ID (0 to 7).
464 Quality of service