Setup Guide

S5148F-ON switch Installation

To install the S5148F-ON switch, complete the installation procedures in the order presented

in this section.

Always handle the switch and its components with care. Avoid dropping the switch or any

eld replaceable units (FRUs).

NOTE: ESD damage can occur if components are mishandled. Always wear an ESD-

preventive wrist or heel ground strap when handling the switch and its components.

As with all electrical devices of this type, take all the necessary safety precautions

to prevent injury when installing this switch.

Topics:

• Unpack

• Rack or cabinet installation

• ReadyRails installation

• 1U Tool-less mount installation

• Two-post ush-mount installation

• Two-post center-mount installation

• Four-post threaded installation

• S5148F-ON installation

• Optics installation

• Switch power-up

• After switch installation

Unpack

NOTE

: Before unpacking the switch, inspect the container and immediately report

any evidence of damage.

S5148F-ON switch Installation 11