Users Guide

Supported Releases 10.2.0E or later
ip route
Assigns a static route on the network device.
Syntax
ip route ip-prefix mask {next-hop | interface interface-type [route-
preference]}
Parameters
• ip-prefix — Enter the IP prex in dotted decimal format (A.B.C.D).
• mask — Enter the mask in slash prex-length format (/x).
• next-hop — Enter the next-hop IP address in dotted decimal format (A.B.C.D).
• interface interface-type — Enter the interface type and interface information. The interface types
supported are: Ethernet, port-channel, VLAN.
• route-preference — (Optional) Enter the range (1 to 255).
Default Not congured
Command Mode CONFIGURATION
Usage Information The no version of this command deletes a static route conguration.
Example
OS10(config)# ip route 200.200.200.0/24 10.1.1.2
Supported Releases 10.2.0E or later
show ip arp
Displays the ARP table entries for specic a IP address or MAC address, static, dynamic, and a summary of all ARP entries.
Syntax
show ip arp [interface [ethernet | vlan | port-channel] | ip-address | mac-address |
static | dynamic | summary]
Parameters
• interface — (Optional) Enter the keyword and interface information:
– ethernet — Enter the node/slot/port[:subport] information.
– vlan — Enter the VLAN ID number (1 to 4093).
– port-channel — Enter the port-channel ID number (1 to 128).
• ip-address — (Optional) Enter the IP address for the ARP entry in A.B.C.D format.
• mac-address — (Optional) Enter the MAC address in nn:nn:nn:nn:nn:nn format.
• static — (Optional) Enter the keyword to display static ARP entries.
• dynamic — (Optional) Enter the keyword to display dynamic ARP entries.
• summary — (Optional) Enter the keyword to display a summary of all ARP entries.
Default Not congured
Command Mode EXEC
Usage Information This command shows both static and dynamic ARP entries.
Example (IP
Address)
OS10# show ip arp ip 192.168.2.2
Protocol Address Age(min) Hardware Address Interface VLAN CPU
248 Layer 3