Users Guide

CPLD2 : 1.0
CPLD3 : 1.0
CPLD4 : 1.0
-- Power Supplies --
PSU-ID Status Type AirFlow Fan Speed(rpm) Status
----------------------------------------------------------------
1 fail
2 up AC NORMAL 1 9056 up
-- Fan Status --
FanTray Status AirFlow Fan Speed(rpm) Status
----------------------------------------------------------------
1 up NORMAL 1 8348 up
2 8585 up
2 up NORMAL 1 8278 up
2 8718 up
3 up NORMAL 1 8420 up
2 8529 up
4 up NORMAL 1 8348 up
2 8680 up
Candidate conguration
When you enter OS10 conguration commands in the transaction-based conguration mode, changes do not take eect immediately and
are stored in the candidate conguration. The conguration changes become active on the network device only after you commit the
changes with the commit command. Changes in the candidate conguration are validated and applied to the running conguration.
The candidate conguration allows you to avoid introducing errors during an OS10 conguration session. You can make changes and then
check them before committing them to the active, running conguration on the network device.
Use the show diff command to check dierences between the running conguration and the candidate conguration. After comparing
the two, you can decide if you would like to commit the changes to the running conguration. Use the discard command to delete
uncommitted changes.
• Enter show ? from EXEC mode to view a list of commands to monitor a device.
OS10# show ?
aaa Current candidate aaa configuration
access-list Current candidate access-list configuration
as-path Current candidate as-path configuration
bgp Current candidate bgp configuration
class-map Current candidate class-map configuration
community-list Current candidate community-list configuration
compressed Current candidate configuration in compressed format
control-plane Current candidate control-plane configuration
dot1x Current candidate dot1x configuration
extcommunity-list Current candidate extcommunity-list configuration
interface Current candidate interface configuration
lacp Current candidate lacp configuration
lldp Current candidate lldp configuration
logging Current candidate logging configuration
monitor Current candidate monitor session configuration
ospf Current candidate ospf configuration
ospfv3 Current candidate ospfv3 configuration
policy-map Current candidate policy-map configuration
prefix-list Current candidate prefix-list configuration
qos-map Current candidate qos-map configuration
radius-server Current candidate radius-server configuration
route-map Current candidate route-map configuration
Getting Started
31