Users Guide

Node Id : 1
MAC : 34:17:eb:3a:bc:80
-- Unit --
Unit Status ReqType CurType Version
----------------------------------------------------------------
1 up S5148F S5148F 10.3.2E(X)
-- Power Supplies --
PSU-ID Status Type AirFlow Fan Speed(rpm) Status
----------------------------------------------------------------
1 fail
2 up AC NORMAL 1 9040 up
-- Fan Status --
FanTray Status AirFlow Fan Speed(rpm) Status
----------------------------------------------------------------
1 up NORMAL 1 8348 up
2 8585 up
2 up NORMAL 1 8295 up
2 8738 up
3 up NORMAL 1 8420 up
2 8529 up
4 up NORMAL 1 8348 up
2 8699 up
Supported Releases
10.2.0E or later
traceroute
Displays the routes that packets take to travel to an IP address.
Syntax
traceroute host [-46dFITnreAUDV] [-f first_ttl] [-g gate,...] [-i device] [-m
max_ttl] [-N squeries] [-p port] [-t tos] [-l flow_label] [-w waittime] [-q
nqueries] [-s src_addr] [-z sendwait] [--fwmark=num] host [packetlen]
Parameters
• host — Enter the host to trace packets from.
• -i interface — (Optional) Enter the IP address of the interface through which traceroute sends packets.
By default, the interface is selected according to the routing table.
• -m max_ttl — (Optional) Enter the maximum number of hops (maximum time-to-live value) that
traceroute probes (default 30).
•
-p port — (Optional) Enter a destination port:
– For UDP tracing, enter the destination port base that traceroute uses (the destination port number is
incremented by each probe).
– For ICMP tracing, enter the initial ICMP sequence value (incremented by each probe).
– For TCP tracing, enter the (constant) destination port to connect.
– -P protocol — (Optional) Use a raw packet of the specied protocol for traceroute. Default protocol is
253 (RFC 3692).
– -s source_address — (Optional) Enter an alternative source address of one of the interfaces. By
default, the address of the outgoing interface is used.
– -q nqueries — (Optional) Enter the number of probe packets per hop (default 3).
– -N squeries — (Optional) Enter the number of probe packets that are sent out simultaneously to
accelerate traceroute (default 16).
556 Troubleshoot OS10