Users Guide

Assign Port Channel IP Address

OS10(config)# interface ethernet 1/1/1

OS10(conf-if-eth1/1/1)# ip address 1.1.1.1/24

OS10(conf-if-eth1/1/1)#

Remove or disable port-channel

You can delete or disable a port-channel.

1 Delete a port-channel in CONFIGURATION mode.

no interface port-channel channel-number

2 Disable a port-channel to place all interfaces within the port-channel operationally down in CONFIGURATION mode.

shutdown

Delete port-channel

OS10(config)# interface port-channel 10

OS10(conf-if-po-10)# no interface port-channel 10

Load balance trac

You can use hashing to load balance trac across the member interfaces of a port-channel. Load balancing uses source and destination

packet information to distribute trac over multiple interfaces when transferring data to a destination.

For packets without an L3 header, OS10 automatically uses the load-balancing mac—selection destination-mac command

for hash algorithms by default.

When you congure an IP and MAC hashing scheme at the same time, the MAC hashing scheme takes precedence over the IP hashing

scheme.

• Select one or more methods of load balancing and replace the default IP 4-tuple method of balancing trac over a port-channel in

CONFIGURATION mode.

OS10(config)# load-balancing

tcp-udp-selection TCP-UDP port for load-balancing configurations

ip-selection IPV4 load-balancing configurations

ipv6-selection IPV6 load-balancing configurations

mac-selection MAC load-balancing configurations

– tcp-upd-selection [l4–destination-port | l4–source-port] — Uses the Layer 4 destination IP address, or

Layer 4 source IP address in the hash calculation.

source-port]

— Uses the destination IP address, source IP address, protocol, VLAN ID, Layer 4 destination IP address, or Layer

4 source IP address in the hash calculation.

source-port]

— Uses the destination IPv6 address, source IPv6 address, protocol, VLAN ID, Layer 4 destination IPv6 address,

or Layer 4 source IPv6 address in the hash calculation.

– mac—selection [destination-mac | source-mac] [ethertype | vlan-id] — Uses the destination MAC

address or source MAC address, and ethertype, or VLAN ID in the hash calculation.

Congure load balancing

OS10(config)# load-balancing ip-selection destination-ip source-ip

Interfaces