Install Guide
Table Of Contents
- Dell EMC PowerSwitch S5200F-ON Series Installation Guide August 2021
- Contents
- About this guide
- S5200F-ON Series switch
- Site preparations
- S5200F-ON Series switch installation
- Power supplies
- Fans
- Management ports
- Specifications
- Chassis physical design
- IEEE standards
- Agency compliance
- USA Federal Communications Commission statement
- European Union EMC directive conformance statement
- Japan VCCI compliance for class A equipment
- Korean certification of compliance
- Safety standards and compliance agency certifications
- Electromagnetic compatibility
- Product recycling and disposal
- Dell EMC support
Table 5. QSFP-DD port LEDs—S5248F-ON (continued)
LED Description
● Solid yellow—Port link operating at a lower speed, 100G,
40G or 10G port
● Flashing yellow, ~30ms—Port activity operating at lower
speed, 100G, 40G or 10G port
● Flashing yellow, ~1 second on/off—Port beacon
Link/Activity LED—8x25GbE or 8x10GbE mode All eight LEDs:
● Off—No link/activity
● Solid green—Link operating at maximum speed, 8x25G
port
● Flashing green—Link activity operating at maximum speed,
8x25G port
● Solid yellow—Link operating at a lower speed, 8x10G port
● Flashing yellow, ~30ms—Port activity operating at lower
speed, 8x10G port
● Flashing yellow, 1 second on/off—Port beacon
Link/Activity LED—2x100G mode First and fifth LEDs:
● Off—No link/activity
● Solid green—Port link operating 2x100G
● Flashing yellow—Port activity at 2x100G port
● Flashing yellow, 1 second on/off—Port beacon
Link/Activity LED—4x50GbE mode First, second, fifth, and sixth LEDs"
● Off—No link/activity
● Solid green—Port link operating 2x50G
● Flashing yellow—Port activity at 2x50G port
● Flashing yellow, 1 second on/off—Port beacon
NOTE: The first QSFP28 LED shows 100GbE, 40GbE, or 10GbE mode. All four QSFP28 port LEDs show 4x25GbE or
4x10GbE mode. The first and third QSFP28 port LEDs show 2x50GbE mode.
Table 6. QSFP28 port LEDs—S5232F-ON, S5248F-ON, and S5296F-ON
LED Description
Link/Activity LED—100GbE, 40GbE, or 10GbE mode First LED:
● Off—No link/activity
● Solid green—Port link operating at maximum speed, 100G
● Flashing green—Port activity operating at maximum
speed, 100G
● Solid yellow—Port link operating at a lower speed, 40G or
10G port
● Flashing yellow, ~30ms—Port activity operating at lower
speed, 40G or 10G port
● Flashing yellow, ~1 second on/off—Port beacon
Link/Activity LED—4x25GbE or 4x10GbE mode All four LEDs:
● Off—No link/activity
● Solid green—Link operating at maximum speed, 4x25G
port
● Flashing green—Link activity operating at maximum speed,
4x25G port
● Solid yellow—Link operating at a lower speed, 4x10G port
● Flashing yellow, ~30ms—Port activity operating at lower
speed, 4x10G port
● Flashing yellow, 1 second on/off—Port beacon
Link/Activity LED—2x50G mode First and third LEDs:
18 S5200F-ON Series switch