Connectivity Guide

31 Dell EMC Networking OS10 Enterprise Edition Switch Configuration Guide for VxRail featuring S5248F-ON,
S5232F-ON and S5148F-ON
Configure switch interconnect - dual switch without VLT
S5148F-Leaf1A
S5148F-Leaf1B
interface port-channel 127
description To_Leaf_1B
switchport mode trunk
switchport trunk allowed vlan 1611-
1615
no shutdown
interface ethernet1/1/53
description To_Leaf_1B
channel-group 127 mode active
no shutdown
interface ethernet1/1/54
description To_Leaf_1B
channel-group 127 mode active
no shutdown
end
write memory
interface port-channel 127
description To_Leaf_1A
switchport mode trunk
switchport trunk allowed vlan 1611-
1615
no shutdown
interface ethernet1/1/53
description To_Leaf_1A
channel-group 127 mode active
no shutdown
interface ethernet1/1/54
description To_Leaf_1A
channel-group 127 mode active
no shutdown
end
write memory
7.3 Single switch
This example uses a four-node VxRail cluster connected to a single switch as shown below.
25GbE connections
Rack 1
S5148F-ON
1/1/23 21 19 17
VxRail node 1
VxRail node 2
VxRail node 3
VxRail node 4
18 20 22 24
Note: The jump box/DNS server, not
shown, is connected to ports 1/1/9
and 1/1/10.
Four-node cluster connected to a single switch
The commands in the following sections are run to complete the switch configuration. The port numbers used
in the configuration commands correspond to those shown in Figure 16.