Connectivity Guide

51 Dell EMC Networking OS10 Enterprise Edition Switch Configuration Guide for VxRail featuring S5248F-ON,

S5232F-ON and S5148F-ON

D.2 Breakout interfaces for S5232F-ON

The S5232F-ON provides 100GbE ports that can be broken into interface(s) with different speeds. The

command options include:

• 100g-1x Breakout to 1x100G interface

• 50g-2x Breakout to 2x50G interfaces

• 40g-1x Breakout to 1x40G interface

• 25g-4x Breakout to 4x25G interfaces

• 10g-4x Breakout to 4x10G interfaces

To configure a breakout for an interface, use the interface breakout command. For example, to

breakout interface 1/1/1 to four 25GbE ports, use the following command:

S5232-R166-Leaf2(config)# interface breakout 1/1/1 map 25g-4x

To verify the broken out ports, use the show interface status command:

S5232-R166-Leaf2(config)# do show interface status

--------------------------------------------------------------------------------

Port Description Status Speed Duplex Mode Vlan Tagged-Vlans

--------------------------------------------------------------------------------

Eth 1/1/1:1 down 0 full A 1 -

Eth 1/1/1:2 down 0 full A 1 -

Eth 1/1/1:3 down 0 full A 1 -

Eth 1/1/1:4 down 0 full A 1 -

Eth 1/1/2 down 0 full A 1 -

Eth 1/1/3 down 0 full A 1 -

Eth 1/1/4 down 0 full A 1 -

---Output Truncated---

D.3 Auto-breakout feature

To automatically detect the pluggable media and provide the needed breakouts, globally enable the auto-

breakout feature using the following command:

S5248F-Leaf1A(config)# feature auto-breakout