Setup Guide

19 Dell EMC SmartFabric OS10 Switch Configuration Guide for VxRail 4.7
6 Switch configuration prerequisites
6.1 Check switch OS version
S5248F-ON switches must be running SmartFabric OS10.5.0.0 or later. Run the show version command
to check the OS version. Dell EMC recommends upgrading to the latest release available on Dell Digital
Locker (account required).
OS10# show version
S5248F-ON# show version
Dell EMC Networking OS10-Enterprise
Copyright (c) 1999-2019 by Dell Inc. All Rights Reserved.
OS Version: 10.5.0.0
Build Version: 10.5.0.0.326
Note: Figure 1 at the beginning of this guide lists supported switches and operating systems for VxRail
deployments.
6.2 Verify license installation
Run the command show license status to verify license installation. The License Type: field should
indicate PERPETUAL. If an evaluation license is installed, licenses purchased from Dell EMC are available for
download on Dell Digital Locker. Installation instructions are provided in the Dell EMC SmartFabric OS10
User Guide Release 10.5.0.
OS10# show license status
System Information
---------------------------------------------------------
Vendor Name : Dell EMC
Product Name : S5248F-ON
Hardware Version: A01
Platform Name : x86_64-dellemc_s5200f_c3538-r0
PPID : CN00Y2VTCES0082O0018
Service Tag : D8MCG02
License Details
----------------
Software : OS10-Enterprise
Version : 10.5.0.0
License Type : PERPETUAL
License Duration: Unlimited
License Status : Active
License location: /mnt/license/D8MCG02.lic
---------------------------------------------------------
Note: If SmartFabric OS10 was factory installed, a perpetual license is already on the switch.