Setup Guide

20 Dell EMC SmartFabric OS10 Switch Configuration Guide for VxRail 4.7
6.3 Factory default configuration
The configuration commands in the sections that follow begin with S5248F-ON switches at their factory
default settings. Dell EMC PowerSwitches running SmartFabric OS10 can be reset to their default
configuration using the serial console port as follows:
OS10# delete startup-configuration
Proceed to delete startup-configuration [confirm yes/no(default)]:y
OS10# reload
System configuration has been modified. Save? [yes/no]:n
Proceed to reboot the system? [confirm yes/no]:y
Note: The above commands can also be performed from an SSH or Telnet session, but the reload
command immediately ends the remote access session to the switch.
The switch reboots to its factory default configuration.
Note: SmartFabric OS10 at its default settings has Telnet disabled, SSH enabled, Rapid per-VLAN Spanning
Tree Plus (RPVST+) enabled, and the OOB management interface configured to get its IP address using
DHCP. The default username and password are both admin. Dell EMC recommends changing the admin
password to a complex password during the first login.