Setup Guide

39 Dell EMC SmartFabric OS10 Switch Configuration Guide for VxRail 4.7
Note: The command output is the same for all topologies in this guide.
8.1.5 show lldp neighbors
The show lldp neighbors command is useful for identifying connected equipment. Interface 1/1/9:1 is
connected to the jump box. Interfaces 1/1/17-20 are connected to the Broadcom adapter in each of the VxRail
nodes, and 1/1/53-54 are connected to the other leaf.
S5248F-Leaf1A# show lldp neighbors
Loc PortID Rem Host Name Rem Port Id Rem Chassis Id
--------------------------------------------------------------------------------
ethernet1/1/9:1 Not Advertised 00:0a:f7:38:ba:a0 00:0a:f7:38:ba:a0
ethernet1/1/17 Broadcom Adv. Dua... 00:0a:f7:b6:15:d0 00:0a:f7:b6:15:d0
ethernet1/1/17 node-63356 00:0a:f7:b6:15:d0 vmnic0
ethernet1/1/18 Broadcom Adv. Dua... 00:0a:f7:b6:1a:80 00:0a:f7:b6:1a:80
ethernet1/1/18 node-94415 00:0a:f7:b6:1a:80 vmnic0
ethernet1/1/19 Broadcom Adv. Dua... 00:0a:f7:b6:11:c0 00:0a:f7:b6:11:c0
ethernet1/1/19 node-38673 00:0a:f7:b6:11:c0 vmnic0
ethernet1/1/20 Broadcom Adv. Dua... 00:0a:f7:b6:1c:10 00:0a:f7:b6:1c:10
ethernet1/1/20 node-86429 00:0a:f7:b6:1c:10 vmnic0
ethernet1/1/53 S5248F-Leaf1B ethernet1/1/53 d8:9e:f3:bf:ae:00
ethernet1/1/54 S5248F-Leaf1B ethernet1/1/54 d8:9e:f3:bf:ae:00
If an entry is not shown for the jump box or laptop computer (port 1/1/9:1 above), it means the NIC on the
remote system does not have LLDP enabled. This is not required and may be ignored for this solution.
Note: For the dual switch without VLT topology, the output is identical to the above. For the single switch
topology, the output includes all eight node-connected ports, and ports 1/1/53-54 are not used.