Dell PowerSwitch S5248F-ON : Setup Guide : Page 47

47 Dell EMC SmartFabric OS10 Switch Configuration Guide for VxRail 4.7

Verify the settings with the following command:

S5248F-Leaf1A(conf-pg-1/1/3)# do show port-group

Port-group Mode Ports FEM

port-group1/1/1 Eth 25g-4x 1 2 3 4 -

port-group1/1/2 Eth 25g-4x 5 6 7 8 -

port-group1/1/3 Eth 10g-4x 9 10 11 12 -

(Output truncated)

The four interfaces in port-group1/1/3 are now set to 10GbE.

Note: The mode command changes the native speed of all interfaces in the port group, eth 1/1/9-1/1/12. In

this guide, only port 1/1/9 is used. Repeat the above commands on the second leaf switch if it is also

connected to a 10GbE adapter on the jump box.

After the port group mode change is made, the interface naming changes from eth 1/1/x to eth 1/1/x:n, where

x is the physical port number, and n is the logical port number. In this example, changing port group 1/1/3 to

10GbE also changes the affected interface names to eth1/1/9:1– 1/1/12:1.

Port-group configuration options for the S5248F-ON are shown in Table 20.

S5248F-ON port-group configuration options

Port

group

number

Native physical

interface name

Native

speed

Other supported speeds

Non-native

logical interface

name

1/1/1

1/1/2

1/1/3

1/1/4

1/1/5

1/1/6

1/1/7

1/1/8

1/1/9

1/1/10

1/1/11

1/1/12

1/1/13

1/1/14

1/1/15

1/1/16

1/1/17

1/1/18

Eth 1/1/1-1/1/4

Eth 1/1/5-1/1/8

Eth 1/1/9-1/1/12

Eth 1/1/13-1/1/16

Eth 1/1/17-1/1/20

Eth 1/1/21-1/1/24

Eth 1/1/25-1/1/28

Eth 1/1/29-1/1/32

Eth 1/1/33-1/1/36

Eth 1/1/37-1/1/40

Eth 1/1/41-1/1/44

Eth 1/1/45-1/1/48

Eth 1/1/49-1/1/50

Eth 1/1/51-1/1/52

Eth 1/1/53

Eth 1/1/54

Eth 1/1/55

Eth 1/1/56

25g-4x

100g-2x

100g-1x

10g-4x

50g-4x 40g-2x 10g-8x 25g-8x

50g-2x 40g-1x 10g-4x 25g-4x

Eth 1/1/x:1

Eth 1/1/x:n