Users Guide

The no version of this command resets the value to the default.
Example (VLAN)
OS10(config)# mac address-table static 34:17:eb:f2:ab:c6 vlan 1
interface ethernet 1/1/30
Example (Port-
Channel)
OS10(config)# mac address-table static 34:17:eb:02:8c:33 vlan 10
interface port-channel 1
Supported
Releases
10.2.0E or later
show switchport port-security
Displays port security information of interfaces.
Syntax
show switchport port-security [interface {ethernet node/slot/port[:subport]
| port-channel port-channel-number}]
Parameters
● interface — Displays the interface type:
○ ethernet node/slot/port[:subport] — Displays the port security information of an
Ethernet interface.
○ port-channel channel-number — Displays the port security information of an Ethernet
interface, from 1 to 128.
Default
None
Command Mode EXEC
Usage
Information
This command displays port security information of all interfaces.
Example
(Address)
OS10# show switchport port-security
Global Port-security status :Enable
Interface name : eth1/1/1
Port Security :Enabled
Port Status :Error-Disable
Mac learn limit :100
MAC-learn-limit-Violation action :Shutdown
Sticky :Disabled
Mac-move-allow :Not Allowed
mac-move-violation action :shutdown-both
Aging :Enabled
Total MAC Addresses :10
Secure static MAC Addresses :0
Sticky MAC Addresses :10
Secure Dynamic MAC addresses :0
Interface name : eth1/1/10
Port Security :Enabled
Port Status :Error-Disable
Mac learn limit :100
MAC-learn-limit-Violation action :Shutdown
Sticky :Disabled
Mac-move-allow :Not Allowed
mac-move-violation action :shutdown-both
Aging :Enabled
Total MAC Addresses :11
Secure static MAC Addresses :0
Security
1421