Users Guide

show sync-e esmc
Displays the ESMC information of all interfaces.
Syntax
show sync-e esmc
Parameters None
Default None
Command Mode EXEC
Usage
Information
This command prints the output of the interfaces only if ESMC and SyncE are enabled on the interfaces and SyncE is enabled
globally.
Example
OS10# show sync-e esmc
Codes: EEC # - Number of cascaded EECs, eEEC # - Number of cascaded eEECs
------------------------------------------------------------------------------------------
Interface Mode QL Rx QL Tx Clock Source Identity Lag EEC # eEEC #
Name
------------------------------------------------------------------------------------------
Eth1/1/5 Disabled - - - - 0 0
Eth1/1/1 Rx and Tx QL-SSU-A QL-PRC 3c:2c:30:ff:fe:04:07:00 po1 0 1
Ethl/1/2 Rx and Tx QL-SSU-A QL-PRC 3c:2c:30:ff:fe:04:07:00 po1 0 2
Ethl/1/3 Rx and Tx QL-PRC QL-DNU 3c:2c:30:ff:fe:04:07:00 po1 0 2
Ethl/1/4 Rx and Tx QL-SSU-B QL-DNU 3c:2c:30:ff:fe:04:07:00 po1 0 1
------------------------------------------------------------------------------------------
Supported
Releases
10.5.2.1 or later
show sync-e interface
Displays the SyncE configuration and status of a specific interface or all interfaces.
Syntax
show sync-e interface [ethernet node/slot/port]
Parameters ethernet node/slot/port—(Optional) Enter a physical Ethernet interface.
Default None
Command Mode EXEC
Usage
Information
This command prints output only when SyncE is enabled globally and on the interfaces.
Example - QL-
enabled mode
OS10# show sync-e interface ethernet 1/1/1
Interface : Ethernetl/1/1
SyncE : Enabled
State : Available
Status : Primary
Signal State : Up
Priority : 128
ESMC Capability : Rx and Tx
QL : QL-SSU-A
QL Received : QL-SSU-A
QL Transmitted : QL-DNU
Hold-off Time : 300 ms
Wait-To-Restore Time : 5 secs
Example - QL-
disabled mode
OS10# show sync-e interface
Interface : Ethernetl/1/1
SyncE : Enabled
State : Available
Status : Secondary
Signal State : Up
Priority : 128
System management 269