Users Guide

a. Create a VLAN.

OS10(config)# interface vlan 30

b. Configure the PVLAN mode as a community VLAN.

OS10(conf-if-vl-20)# private-vlan mode community

c. Configure a secondary port.

OS10(config)# interface ethernet 1/1/3

OS10(conf-if-eth1/1/3)# switchport mode trunk

OS10(conf-if-eth1/1/3)# private-vlan mode secondary-port

d. Associate the secondary port to the community VLAN.

OS10(conf-if-eth1/1/2)# switchport trunk allowed vlan 30

4. Associate the list of secondary VLANs to the primary VLAN.

OS10# configure terminal

OS10(config)# interface vlan 10

OS10(conf-if-vl-10)# private-vlan mapping secondary-vlans 20, 30

OS10# show vlan private-vlan mapping

Private Vlan:

Primary : 10

Isolated : 20

Community : 30

OS10# show vlan private-vlan

Primary Secondary Type Active Ports

------- --------- --------- ------ --------------------------------------------

10 Primary Yes Eth1/1/1,1/1/5

20 Isolated Yes Eth1/1/2

30 Community Yes Eth1/1/3

OS10# show vlan

Codes: * - Default VLAN, M - Management VLAN, R - Remote Port Mirroring VLANs,

@ – Attached to Virtual Network, P - Primary, C - Community, I - Isolated

Q: A - Access (Untagged), T - Tagged

NUM Status Description Q Ports

* 1 Active A Eth1/1/4,1/1/6-1/1/32

P 10 Active A Eth1/1/1

T Eth1/1/5

I 20 Active T Eth1/1/2

C 30 Active A Eth1/1/3