Deployment Guide

14 Dell EMC Solutions for Microsoft Azure Stack HCI Networking Guide
5 Configure network adapters
Note: Exact iDRAC steps in this section may vary depending on hardware, software and browser versions
used. See the PowerEdge server documentation for steps to connect to the iDRAC.
5.1 Reset network adapters to factory defaults
Note: These steps are only necessary for network adapters that have been modified from their factory default
settings.
1. Connect to the server's iDRAC in a web browser and launch the virtual console.
2. In the virtual console, from the Next Boot menu, select BIOS Setup.
3. Reboot the server.
4. On the System Setup Main Menu page, select Device Settings.
Device Settings menu item
5. On the Device Settings page, click the first network adapter port in the list to launch the Main
Configuration Page for the port.
First NIC port in the device list