Deployment Guide
34  Dell EMC Solutions for Microsoft Azure Stack HCI Networking Guide 
 A 
Eth1/1/21:1,1/1/22:1,1/1/23:1,1/1/24:1,1/1/31:1 
 1613 Active Storage_1 T Eth1/1/1-1/1/4 
 T Po1000 
 1614 Active Storage_2 T Eth1/1/1-1/1/4 
 T Po1000 
 4094 Active T Po1000 
8.1.3  show lldp neighbors 
The show lldp neighbors command is useful for identifying connected equipment by port.  
Note: Mellanox ConnectX-4 Lx adapters set to “Host in Charge” per Section 9.12 have LLDP disabled. After 
the “Host in Charge” setting is made, switch ports connected to the Mellanox adapters will not appear in the 
output of this command. 
S5248F-Leaf1A# show lldp neighbors 
Loc PortID Rem Host Name Rem Port Id Rem Chassis Id 
--------------------------------------------------------------------------------
------ 
ethernet1/1/1 Not Advertised 24:8a:07:8e:9f:1b 24:8a:07:8e:9f:1d 
ethernet1/1/2 Not Advertised 24:8a:07:9a:ac:8b 24:8a:07:9a:ac:8d 
ethernet1/1/21:1 Not Advertised e4:43:4b:1e:3c:cc  e4:43:4b:1e:3c:cc 
ethernet1/1/22:1 Not Advertised e4:43:4b:1e:30:aa  e4:43:4b:1e:30:aa 
ethernet1/1/23:1 Not Advertised e4:43:4b:1e:3f:30  e4:43:4b:1e:3f:30 
ethernet1/1/24:1 Not Advertised e4:43:4b:1e:31:54  e4:43:4b:1e:31:54 
ethernet1/1/3 Not Advertised 24:8a:07:9a:ac:a3  24:8a:07:9a:ac:a5 
ethernet1/1/31:1 Not Advertised 18:66:da:71:50:a4  18:66:da:71:50:a4 
ethernet1/1/4 Not Advertised 24:8a:07:8e:9d:fb  24:8a:07:8e:9d:fd 
ethernet1/1/49 S5248F-Leaf1B ethernet1/1/49  3c:2c:30:10:34:00 
ethernet1/1/50 S5248F-Leaf1B ethernet1/1/50  3c:2c:30:10:34:00 
ethernet1/1/51 S5248F-Leaf1B ethernet1/1/51  3c:2c:30:10:34:00 
ethernet1/1/52 S5248F-Leaf1B ethernet1/1/52  3c:2c:30:10:34:00 
mgmt1/1/1 R168U39-S3048 ethernet1/1/38  74:e6:e2:f5:c8:80 
8.1.4  show vrrp brief 
In this deployment, VRRP is configured on the in-band management VLAN, 1611, to provide gateway 
redundancy for management and VM traffic. The output from the show vrrp brief command shows the 
master and virtual IP addresses and whether the switch is in the master or backup role. The switch configured 
with the largest priority value, shown in the Priority column, is the VRRP master. 
S5248F-Leaf1A# show vrrp brief 
Interface Group Priority Prempt State Version Master addr(s) Virtual addr 
-------------------------------------------------------------------------------- 
vlan1611 IPv4 11 150 true master 2 172.16.11.252 172.16.11.254   










