Deployment Guide

4 Dell EMC Solutions for Microsoft Azure Stack HCI Networking Guide
7.6 Configure VLT ................................................................................................................................................... 29
7.7 Configure DCB .................................................................................................................................................. 30
8 Switch validation ......................................................................................................................................................... 33
8.1 General commands .......................................................................................................................................... 33
8.1.1 show interface status ........................................................................................................................................ 33
8.1.2 show vlan .......................................................................................................................................................... 33
8.1.3 show lldp neighbors .......................................................................................................................................... 34
8.1.4 show vrrp brief .................................................................................................................................................. 34
8.2 VLT validation commands ................................................................................................................................ 35
8.2.1 show vlt domain_id ........................................................................................................................................... 35
8.2.2 show vlt domain_id backup-link ........................................................................................................................ 35
8.2.3 show vlt domain_id mismatch ........................................................................................................................... 36
9 S2D Ready Node configuration and deployment ....................................................................................................... 37
9.1 Initial state ......................................................................................................................................................... 37
9.2 Ensure DCB is disabled on Intel X710 adapters .............................................................................................. 38
9.3 Install roles and features .................................................................................................................................. 39
9.4 Configure the in-band management and VM network ...................................................................................... 39
9.5 Configure storage networks .............................................................................................................................. 40
9.5.1 Configure storage VLANs ................................................................................................................................. 40
9.5.2 Configure storage IP addresses ....................................................................................................................... 40
9.5.3 Enable RDMA ................................................................................................................................................... 41
9.5.4 Enable iWARP on QLogic adapters ................................................................................................................. 41
9.5.5 Enable jumbo frames on NICs .......................................................................................................................... 41
9.6 Join Ready Nodes to the Active Directory domain ........................................................................................... 42
9.7 Clean disks ....................................................................................................................................................... 42
9.8 Run the Test-Cluster cmdlet ............................................................................................................................. 44
9.9 Create the cluster ............................................................................................................................................. 44
9.10 Configure a cluster witness .............................................................................................................................. 45
9.11 Enable S2D ....................................................................................................................................................... 46
9.12 Create storage volumes ................................................................................................................................... 46
9.13 Configure DCB on Ready Nodes ...................................................................................................................... 47
10 PowerShell validation commands and output ............................................................................................................ 48
10.1 Get-NetAdapter ................................................................................................................................................. 48
10.2 Get-VMSwitch ................................................................................................................................................... 48
10.3 Get-NetIPAddress ............................................................................................................................................ 49
10.4 Get-NetRoute .................................................................................................................................................... 49