Users Guide

Usage
Information
The no version of this command resets the value to the default.
Example
OS10(conf-range-eth1/1/7-1/1/8)# dot1x timeout supp-timeout 45
Supported
Releases
10.2.0E or later
dot1x timeout tx-period
Sets the number of seconds that the device waits for a response to an EAP-request/identity frame from the supplicant before
retransmitting the request.
Syntax
dot1x timeout tx-period seconds
Parameters tx-period seconds — Enter the number of seconds for the 802.1X transmission timeout, from 1 to
65535.
Default 60 seconds
Command Mode INTERFACE
Usage
Information
The no version of this command resets the value to the default.
Example
OS10(conf-range-eth1/1/7-1/1/8)# dot1x timeout tx-period 120
Supported
Releases
10.2.0E or later
show dot1x
Displays global 802.1X configuration information.
Syntax
show dot1x
Parameters None
Default Not configured
Command Mode EXEC
Usage
Information
None
Example
OS10# show dot1x
PAE Capability: Authenticator only
Protocol Version: 2
System Auth Control: Enable
Auth Server: Radius
Supported
Releases
10.2.0E or later
show dot1x interface
Displays 802.1X configuration information.
Syntax
show dot1x interface ethernet node/slot/port[:subport]
Parameters ethernet node/slot/port[:subport] — Enter the Ethernet interface information.
Command Mode EXEC
Layer 2 407