Deployment Guide

14 Dell EMC Networking OS10EE FCoE Deployment with FSB

5 S5248-ON FSB leaf switch configuration

This section details steps to configure the S5248-ON leaf switches running OS10EE.

5.1 Prepare switches

5.1.1 Factory default configuration

The configuration commands in the sections that follow begin with S5248-ON switches at their factory default

settings. Dell EMC PowerSwitch models running OS10EE can be reset to their default configuration as

follows:

OS10# delete startup-configuration

Proceed to delete startup-configuration [confirm yes/no(default)]:y

OS10# reload

System configuration has been modified. Save? [yes/no]:n

Proceed to reboot the system? [confirm yes/no]:y

The switch reboots to its factory default configuration. Repeat on the second S5248-ON switch.

Note: OS10EE at its default settings has Telnet disabled, SSH enabled, and the OOB management interface

that is configured to get its IP address using DHCP. The default username and password are both admin.

Dell EMC recommends changing the admin password to a complex password during the first login.

5.2 Configure switches

The commands in the tables that follow are run to complete the leaf and FSB configuration on both switches.

Note: The commands in the tables below should be entered in the order shown. Switch running-configuration

files are provided as attachments named S5248-Leaf1.txt and S5248-Leaf2.txt.

5.2.1 Configure global switch settings

Configure the hostname, OOB management IP address, and OOB management default gateway.

Configure the port group 1/1/11 for 10GbE. These interfaces are used to connect to the S4148U-ON FCF

switches.

S5248-Leaf1

S5248-Leaf2

configure terminal

hostname S5248-Leaf1

interface mgmt 1/1/1

no ip address dhcp

ip address 100.67.166.224/24

no shutdown

management route 0.0.0.0/0

100.67.166.254